✓
TECHNICAL VALUES

APPLICATION

SURFACE PREPARATION

• The surface of application shall be free solid, clean and free of dust.
• The surface shall always be free of materials such as form oil, paint, dust etc, and shall be fully cured.
• Parts on the surface (iron, wood, etc.) shall be removed and these hole shall be filled with appropriate Entegre Repair Mortars.
• You may advance to application after dampening the surface.

PREPARATION of the MORTAR

• A proper amount of fluid component shall be put inside the mixing vessel (5 kg of fluid/20 kg of powder).
• Whole bag is poured to the vessel, and stirred with hand mixer until the lumps are removed.
• After resting for 5 minutes, the mortar shall be stirred again.
• ENTEGRE CHAMFERING TAPE shall be applied to the connection points of the application surfaces using EPODOL®.
• If you do not prefer chamfering tapes, bring the connection points to an oval form and reinforce them with nets.
• Fluid mortar shall be applied with a brush or a roll.
• Second coat shall be perpendicular to the first coat and shall be applied at least for 6 hours later.
• Wait 3 days for application of final coat (ceramic, screed and cement-based plaster), and take care to prevent mechanical damage to the insulation material during coating.
• If the application area is a water tank, wait at least 28 days for the curing of the product.

1

2

3

▶
APPLICATION VIDEO

For more information, please watch our application video.

📊
CONSUMPTION

1.5-2.0 kg/m² single coat

(Single coat of application at proper surface and ambient conditions is taken as a reference. It may differ as per surface specifications and application conditions.)

⚠
RECOMMENDATION

• No other materials than these two components (lime, cement, gypsum, etc.) shall be added.
• We recommend you to stir the product continuously during application.
• Mortar shall not be used again by mixing with water, fluid component or dry mortar if its application time has expired.
• We recommend that the application shall be performed between +5°C and +35°C.
• SUTOP FAIR® shall be protected against effects such as sunlight, wind, rain and frost, etc. within the first 24 hours after application.
• Reaches its final strength within 14 days.
• It shall not be applied on frozen surfaces.
• Do not apply under direct sunlight.
• Do not go beyond the application field and the rules.
• Do not inhale it directly. Wash your eyes with plenty of water in case of contact with eyes, seek medical attention if required.
• For detailed information, please request the security data sheet.
• Contact us for your technical questions and for your questions about all other application conditions.