✓
APPLICATION FIELD

Applied on brick, aerated concrete, concrete, fair faced concrete, pumice concrete, briquette walls and ceiling surfaces on both interior and exterior faces of the buildings.

+
REQUIREMENTS

• Serves as both the rough plaster and finish plaster as a single product.
• It can be easily and rapidly applied.
• Provides a strong surface with high adhesive resistance and strength.

✓
TECHNICAL VALUES

APPLICATION

SURFACE PREPARATION

• The surface of application will always be free of form oil, dust, paint and materials that reduce adherence.
• Repair of the cracks and holes should be made with the same material or using appropriate Entegre Repair Mortars before application.
• Application surface should be dampened with water, if required.
• Pre-coating will be performed using PRIMEL® for surfaces such as aerated concrete, bricks, etc. 1 day before the application; and using PRIMEL® PLUS for smooth surfaces such as fair faced concrete 1 day before the application.
• Application is started when the surface is dry.

PREPARATION of the MORTAR

• ELTEK® should be mixed with ready-mix plaster mixer or by hand (9-11 l water/50 kg bag).
• The mortar prepared will be applied with a plastering trowel.
• It should be applied in 2 coats.
• Application thickness should be between 1 cm and 2.5 cm in one coat.
• If the thickness is more than 2.5 cm, a second coat is applied in max. 2.5 cm thickness after the first coat is set.
• Surface must be levelled.
• The surface of the plaster will be polished when the plaster becomes hard enough and the surface will be finished with a damp sponge.

▶
APPLICATION VIDEO

For more information, please watch our application video.

📊
CONSUMPTION

Approx. 15,0 kg/m² for 1 cm of plaster thickness

⚠
RECOMMENDATION

• No other materials (lime, cement, gypsum, etc.) should be added to the prepared plaster.
• Application should be performed between +5°C and +35°C.
• ELTEK® will be protected against quick drying under windy weather conditions.
• Fiberglass meshs should be used on the joining areas of different materials and on the points that may be considered to be moving.
• Wait at least 10 days for the application to be performed on the ELTEK® depending on the ambient temperature.
• Surface should be watered in specific intervals within 3 days after the application to ensure its strength.
• Do not go beyond the application field and the rules.
• Do not inhale it directly. Wash your eyes with plenty of water in case of contact with eyes, seek medical attention if required.
• For detailed information, please request the safety data sheet.
• Contact us for your further inquires and about all other application conditions.