✓
APPLICATION FIELD

Provides superior performance in fixing of coating materials such as ceramic, granite, marble, etc. on horizontal and vertical surfaces for interior and exterior areas.

It may be applied on dry and wet areas, cement-based plasters and concrete surfaces, floorings with floor heating system, and floors with high level of traffic passing over them.

+
REQUIREMENTS

• It has polymer additives.
• Resistant to water and freezing.
• Provides a good performance with its elasticity.
• Used conveniently on interior and exterior surfaces both vertically and horizontally.

✓
TECHNICAL VALUES

APPLICATION

SURFACE PREPARATION

• The surface shall always be free of form oil, dust, paint and materials that reduce adherence.
• Repair of the cracks and holes shall be made using appropriate Entegre Repair Mortars before application.
• Application surface shall be dampened with water, if required.
• PRIMEL 100® shall be applied before application on surfaces that are not resistant to moisture such as plasterboard, cardboard, gypsum plasters, etc. and the fixing operation is started when drying is complete (after approx. 24 hours).

PREPARATION of the MORTAR

• Water shall be put to the mixing vessel first, then KAROFIX FLEX® shall be added (5.75-6.25 l water/25 kg bag) and it shall be stirred until the lumps are removed.
• Wait for 5 minutes, and stir again to achieve a homogeneous mixture.
• The mortar prepared shall be applied up to a thickness of 8 mm, it shall be combed and ceramic shall be fixed.
• For a good adhesion, application shall be performed by applying force on the surface with a rubber hammer.
• Double sided fixing shall be used for coatings greater than 1,600cm².

▶
APPLICATION VIDEO

For more information, please watch our application video.

📊
CONSUMPTION

Applies for application on a single side.

⚠
RECOMMENDATION

• No other materials (lime, cement, gypsum, etc.) shall be added to the prepared mortar.
• Plaster shall not be used again by mixing with water or dry plaster if its application time has expired.
• You shall wait at least 24 hours for joint application.
• May be used for coatings with water absorption of ≤0.5 and > 0.5 (ceramic, granite and porcelain ceramic, marble, etc.).
• Coating areas specified below are suitable for an ideal application:
  • For the interior floors ≤1600 cm²
  • For the exterior floors ≤1200 cm²
  • For interior and exterior walls: coating area ≤1200 cm² (4 m height)
• KAROFIX FLEX® White is recommended for light coloured coatings.
• We recommend that the application shall be performed between +5°C and +35°C.
• For an ideal application, coating material shall be fixed to the mortar applied on the surface within 25 minutes.
• We recommend you to take additional mechanical precautions for heights over 8m.
• It shall not be applied on frozen surfaces.
• Do not apply under direct sunlight.
• Do not go beyond the application field and the rules.
• Do not inhale it directly. Wash your eyes with plenty of water in case of contact with eyes, seek medical attention if required.
• For detailed information, please request the security data sheet.
• Contact us for your technical questions and for your questions about all other application conditions.