FiNTEK®

Cement-Based Thin Finishing Plaster

✓
APPLICATION FIELD

Applied as a thin finishing plaster on traditional and ready-mixed cement-based plaster applications both on interior and exterior surfaces.

+
REQUIREMENTS

Provides a smooth surface for final coating.
Provides cost advantage.
It can be easily and rapidly applied.

✓
TECHNICAL VALUES

Dry Bulk Density of Hardened Mortar, kg/m³
1600 ± 300

Compressive Strength, N/mm²
≥ 6,0 (CS IV)

Adhesive Strength, N/mm²
≥ 0,2 (FP:B)

Capillary Water Absorption, kg/m² min0.5
W0

Water Vapour Permeability Coefficient, µ
≤ 25

Average Thermal Conductivity, W/m.K (λ10,dry)
≤ 0,93

Reaction to Fire
A1

APPLICATION

SURFACE PREPARATION

The surface will always be free of form oil, dust, paint and materials that reduce adherence.
Repair of the cracks and holes should be made using appropriate Entegre Repair Mortars before application.
Application surface should be dampened with water, if required.

PREPARATION of the MORTAR

FINTEK® should be mixed with ready-mix plaster mixer or by hand (4.5-5,5 lt water/25 kg bag).
Application thickness should be between 3 -10 mm for one coat and it will be applied using a plastering trowel.
The surface of the plaster will be polished when the plaster becomes hard enough and the surface will be finished with a damp sponge.

▶
APPLICATION VIDEO

For more information, please watch our application video.

📊
CONSUMPTION

Approx. 1.7 kg/m² for 1 mm of thickness

📦
PACKAGING

25 kg Paper Bag,
(delivered in pallets or as sling-bags upon request.)

💾
STORING

1 Year Shelf Life*
* If stored in its original package without opening the package under dry, frost free conditions
(1 week after opening the package.)

⚠
RECOMMENDATION

No other materials (lime, cement, gypsum, etc.) should be added to the prepared mortar.
We recommend the application to be performed between +5°C and +35°C.
FINTEK® will be protected against quick drying under windy weather conditions.
Surface should be watered in specific intervals within 3 days after the application to ensure its strength.
We recommend application of 2 coats to prevent cracking risk due to fast curing when required, particularly for applications performed on summer days.
We recommend using fiberglass meshs on the joining areas of different materials and on the points that may be considered to be moving.
You should wait at least 10 days for the application be performed on the FINTEK® depending on the ambient temperature.
Do not go beyond the application field and the rules.
Do not inhale it directly. Wash your eyes with plenty of water in case of contact with eyes, seek medical attention if required.
For detailed information, please request the safety data sheet.
Contact us for your further inquires and about all other application conditions.